Herunterladen Inhalt Inhalt Diese Seite drucken

D Function Of Detergent - Blaupunkt 5VT710NA Montage- Und Gebrauchsanweisung

Einbau geschirrspüler, vollintegriert
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
When to Refi ll the Rinse Aid Dispenser
If there is no rinse-aid warning light in the control panel, you can estimate the amount from the colour of the optical level
indicator C located next to the cap. When the rinse-aid container is full, the whole indicator will be dark.As the rinse-aid
diminishes, the size of the dark dot decreases. You should never let the rinse aid level fall 1 / 4 full.
As the rinse aid diminishes, the size of the black dot on the rinse aid
level indicator changes, as illustrated below.
Full
3 / 4 full
1 / 2 full
1 / 4 full - Should refi ll to eliminate spotting
Empty
1
1
To open the dispenser, turn the cap to the „open" (left) arrow and lift it out.
2
Pour the rinse aid into the dispenser, being careful not to overfi ll.
Replace the cap by inserting it aligned with „open" arrow and turning it to the closed (right) arrow.
3
NOTE:
Clean up any rinse aid spilled while during fi lling with an absorbent cloth to avoid excessive foaming during the
next wash. Don't forget to replace the cap before you close dishwasher door.
Adjusting Rinse Aid Dispenser
Adjust lever
(Rinse)
D� Function of Detergent
Detergents with its chemical ingredients are necessary to remove dirt, crush dirt and transport it out of the dishwasher.
Most of the commercial quality detergents are suitable for this purpose.
Attention!
Proper Use of Detergent
Use only detergent specifi cally made for the use in dishwashers. Keep your detergent fresh and dry.
Don't put powdered detergent into the dispenser until you're ready to wash dishes.
2
The rinse aid dispenser has six or four settings. Always start with the dispenser
set on „4". If spots and poor drying are a problem, increase the amount of rinse aid
dispensed by removing the dispenser lid and rotating the dial to „5". If the dishes still
are not drying properly or are show spots, adjust the dial to the next higher lever until
your dishes are spot-free. The recommended setting is „4". (Factory value is „4".)
NOTE:
Increase the dose if there are drops of water or lime spots on the dishes after washing. Reduce it
if there are sticky whitish stains on your dishes or a bluish fi lm on glassware or knife blades.
39
C (Rinse-Aid indicator)
3

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis