Quick Operation Guide - Blaupunkt 5VT710NA Montage- Und Gebrauchsanweisung

For detailed operating method read the corresponding content on the instruction manual.
Switch on the appliance
Fill the detergent dispenser
Check the rinse aid level
Check the regeneration salt
level
Load the baskets
Select a programme
Running the dishwasher
Changing the programme
Add forgotten dishes in the
dishwasher.
If the appliance is switched
off during a wash cycle.
Switch off the appliance
Turn off the water tap,
unload the baskets

Quick operation guide

Open the door, press the On/Off button to switch on the appliance.
Compartment A:
With each wash cycle.
Compartment B:
For programmes with pre-wash only.
(Follow the user instructions!)
Mechanical indicator C�
Electric indicator on control panel (if provided).
(On models with water softener system only.) Electric indicator on
control panel (if provided).
If there is no salt warning light in the control panel (for some
models), you can estimate when to fi ll the salt into the softener
by the number of cycles the dishwasher has run.
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans,
then load the baskets. Refer to the dishwasher loading instructions.
Press the Programme Button until the selected programme lights up.
(See the section entitled Operation instruction)
T urn on the water tap, close the door. The machine will start working after about 10 seconds.
1. A running cycle can only be modifi ed if it has been running for a short time. Otherwise the detergent
may have already been released and the water already drained. If this is the case, the detergent dispenser
must be refi lled.
2. Open the door.
Programme Button
3. Press the
4. Select a new programme.
5. Restart the dishwasher.
1.Open the door a little to stop the dishwasher.
2.After the spray arms stop working, you can open the door completely.
3.Add the forgotten dishes.
4.Close the door, the dishwasher will start running again after 10 seconds.
If the appliance is switched off during a wash cycle, when switched on again, please re-select the was-
hing cycle and If the appliances is switched off during a wash cycle, when switched on again, please
re-select the washing cycle and it will start operating from where it stopped.
When the working cycle has fi nished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the On/Off Button.
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to avoid handling the
dishes and utensils while they are still hot and more susceptible to break.
They will also dry better.Unload the appliance, starting from the lower basket.
35
for more than 3 seconds to cancel the running programme.
B
C
A
WARNING!
Open the door carefully.
Hot steam may escape
when the door is opened!