Inhaltsverzeichnis
Werbung
USB 3.0 Header
(19-pin USB3_4_5)
(see p.1, No. 8)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, No. 27)
Chassis Speaker Header
(4-pin SPEAKER1)
(see p.1, No. 19)
Chassis and Power Fan
Connectors
(4-pin CHA_FAN1)
(see p.1, No. 16)
(3-pin CHA_FAN2)
(see p.1, No. 29)
Downloaded from
www.Manualslib.com
IntA_PA_SSRX-
IntA_PA_SSRX+
IntA_PA_SSTX-
IntA_PA_SSTX+
IntA_PA_D-
IntA_PA_D+
1
1. High Deinition Audio supports Jack Sensing, but the panel wire on the chassis must
support HDA to function correctly. Please follow the instructions in our manual and
chassis manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to con-
nect them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel
and adjust "Recording Volume".
DUMMY
1
+5V
FAN_SPEED_CONTROL
manuals search engine
Besides four USB 3.0
Vbus
Vbus
Vbus
IntA_PB_SSRX-
ports on the I/O panel,
IntA_PB_SSRX+
GND
there is one header on this
GND
IntA_PB_SSTX-
IntA_PB_SSTX+
motherboard. Each USB
GND
GND
IntA_PB_D-
3.0 header can support
IntA_PB_D+
Dummy
two ports.
1
his header is for
GND
PRESENCE#
MIC_RET
connecting audio devices
OUT_RET
to the front audio panel.
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L
Please connect the chassis
SPEAKER
speaker to this header.
DUMMY
Please connect fan cables
4
FAN_SPEED
3
to the fan connectors and
+ 12V
2
GN D
1
match the black wire to
the ground pin.
CHA_FAN_SPEED
FAN_VOLTAGE
GND
Z97 Pro4
25
Werbung
Inhaltsverzeichnis
