Inserting The F Ilter - SOLIS 558 Bedienungsanleitung

Solis_DigitalKettle-Betriebsanleitung.indd 3 0
Downloaded from www.Manualslib.com
Keep warm: After selecting this function, the display will indicate 70° C . Use the «+ » and «-» buttons to
select the required temperature in steps of 5 degrees each. Press the ON/OFF button when the temperature
y ou require is indicated; the heating process then begins. The appliance will switch itself off once the
set temperature has been reached. If the water temperature falls below y our chosen temperature by more
than 2° C , the heating programme will re-start until the programmed temperature has been reached
again. Once the temperature programmed in the «Keep warm» function has been reached, the required
temperature will show continuously on the display instead of the current water temperature. The «Keep
warm» function will stay activated for 120 minutes. At the end of this interval, the appliance switches
itself off. If the water jug is lifted off the base station and then replaced, the «Keep warm» function will
be deactivated.
5 . S witching of f
Press the ON/OFF down for 3 seconds to switch the appliance off. If y ou subsequently press
the ON/OFF button again for 3 seconds, the appliance will enter the Standby mode.
6 . S tandby mode
The heating element switches off and the display indicates the current water temperature.
7 . P ouring the water out
Take the water jug off the base station and pour the water out.

INSERTING THE F ILTER

Insert the filter into the
water jug in the direction
of the arrow.
30
manuals search engine
Fit the two top hooks
in the openings on the
casing first.
Then place the lower hook
into the opening in the
direction of the arrow.
Press lightly
against the filter
from below
16 .0 2 .11 18 :0 1