Switching The Appliance Off; Good To Know - Solis 5515 Bedienungsanleitung

Achtung: Es erfolgt keine automatische Fortsetzung der Warmhaltefunktion.
Caution: When heating water, the lid should be shut at all times.
o Nach dem erneuten Aufsetzen der Kanne kann die Warmhaltefunktion fortgesetzt werden, indem die
Note: The warm-keeping function is not activated in the "Heat up" program!
o After the jug has been put back, the keep warm function can be continued by pressing the
Taste „START" erneut gedrückt wird.
"START" button anew.
o Nach dem erneuten Aufsetzen der Kanne kann die Warmhaltefunktion fortgesetzt werden, indem die
o Am Ende der Warmhaltezeit ertönt ein 6facher Signalton und das Gerät schaltet in den Standby-Modus.
o Once the keep warm time has run down, there is a 6-times signal tone and the appliance will switch
Taste „START" erneut gedrückt wird.
s CLASSIC WATER COOKER:
over to standby mode.
o Am Ende der Warmhaltezeit ertönt ein 6facher Signalton und das Gerät schaltet in den Standby-Modus.
7. Schnellstart-Funktion „BOILING"
QUICK START FUNCTION (BOILING)
7. Schnellstart-Funktion „BOILING"
7. Quick-start function (BOILING)
• Das Gerät ist mit einer Schnellstarttaste zum Kochen von Wasser ausgestattet.
• Diese Funktion hat keinen vorprogrammierten Ablauf.
• Das Gerät ist mit einer Schnellstarttaste zum Kochen von Wasser ausgestattet.
o Zum Starten der Schnellstart-Funktion drücken Sie die Taste „BOILING".
• The appliance has a quick-start button for bringing water to the boil. The appliance is equipped with a quick start function to heat water to
• Diese Funktion hat keinen vorprogrammierten Ablauf.
o Das Gerät startet den Kochvorgang. Dies wird mit einem kurzen Signalton angezeigt.
• There is no preset order for this function.
100°C in the shortest amount of time.
o Zum Starten der Schnellstart-Funktion drücken Sie die Taste „BOILING".
o To activate the quick-start function just press the "BOILING" button.
o Im Display ist ab einer Temperatur von 30 °C die aktuelle Temperatur zu sehen. Diese ändert sich jeweils in 5
o Das Gerät startet den Kochvorgang. Dies wird mit einem kurzen Signalton angezeigt.
o The appliance commences the boiling, indicated by a short signal tone.
°C Schritten.
There are no presets for the water cooker function.
o Im Display ist ab einer Temperatur von 30 °C die aktuelle Temperatur zu sehen. Diese ändert sich jeweils in 5
o As of 30 °C the display shows the current temperature in steps of 5 °C.
• Nach Beendigung des Kochvorganges schaltet das Gerät automatisch in den Auswahl-Modus.
• Once the boiling has been completed, the appliance automatically switches over to selection-mode. °C Schritten.
•
Place the water-fi lled jug on the appliance base without the tea strainer. The
• Im Display wird die Programmauswahl 1„Herbal" angezeigt.
• The display shows the programme selection 1 "Herbal".
• Nach Beendigung des Kochvorganges schaltet das Gerät automatisch in den Auswahl-Modus.
outside of the jug and the appliance base have to be dry, the lid has to be shut.
8. Gerät ausschalten
• Im Display wird die Programmauswahl 1„Herbal" angezeigt.
• Connect the power plug to the power outlet, "Herbal 100°C" lights up in the
8. Gerät ausschalten
8. Switching off
display.
• The running programme or function can be interrupted any time. The appliance is set in selection-mode.
• To start the water cooker, simply press the BOILING button.
• To do so, press the "START" button for 2 seconds or unplug the power plug from the mains.
• After each use pull the mains plug to ensure a safe switch off!
• A short signal sounds, the appliance starts heating up.
•
Once the water temperature has reached 30°C, this is stated on the display. The
further increase in heat can be told from the display in steps of 5°C.
•
Once the water has come to the boil, a sixfold signal sounds, the appliance auto-
matically switches to operating mode and the program 1, "Herbal", reappears
in the display.
Caution: When classically boiling water, the lid should be shut at all times.
Note: The warm-keeping function is not activated in the water cooker function
24
BOILING.
128
s SWITCHING THE APPLIANCE OFF
• Every program and every function can be interrupted at all times. To do so, you
can press the START button for 2 seconds to switch the appliance to operating
mode.
• To switch the appliance off, press the START button for 2 seconds to switch the
appliance to operating mode and then pull the power plug to disconnect the
appliance from the power.
•
The power plug should be pulled after every use, so that the appliance is com-
pletely disconnected from the power and switched off.
OV E R HE AT PR OTE C T IO N OV E R H E AT P R O TE C TI ON
Should the appliance overheat, e.g. if there is no or too little water in the jug Should the appliance overheat, e.g. if there is no or too little water in the jug
or if it has already evaporated, the appliance automatically switches off. In this or if it has already evaporated, the appliance automatically switches off. In this
case, pull the plug and let the appliance cool down for approx. 30 minutes case, pull the plug and let the appliance cool down for approx. 30 minutes
before using it again.The buttons can only be used again once the appliance before using it again.The buttons can only be used again once the appliance
has cooled down suffi ciently. Never try to cool the appliance down by fi lling has cooled down suffi ciently. Never try to cool the appliance down by fi lling
it with cold water! Always let the appliance cool down between two heating it with cold water! Always let the appliance cool down between two heating
phases. phases.
13
s GOOD TO KNOW
13
1. Never exceed the MAX marking when fi lling the jug as this might cause the
water to splash out of the jug during boiling and cause scalding resp. electric
shock!
2. Filled to the MAX marking, the jug holds 1,2 litres of water.
3. Never fi ll the jug with too little water. The MIN marking (500 ml) has to be
reached every time, otherwise the overheat protection is triggered and the
appliance switches off.
4. Always check if the lid is correctly closed before connecting the power plug to
the socket.
5. Dry the outside of the jug including the jug bottom as well as the appliance base
before plugging in the plug.
6. During a program, you can deactivate it at any time by pressing the START but-
ton for 2 seconds.
7. Should there be too little water in the jug or should the water have evaporated,
thereby triggering the overheat protection, pull the plug and let the appliance
cool down for 30 minutes before refi lling cold water into the jug.
129