Grounding - VOSS.farming impuls duo DV 40 Bedienungsanleitung

DE EN FR IT NL SV ES
other terminal. Just before the tip of the screwdriver touches the second terminal, you
should see a small, harmless spark.
If the control LED (3) or the LED bar (4) do not light up and/or there is no spark, then check
the power supply first: connection to mains or battery voltage. If there is no fault here,
the device should be checked by a specialist.
NOTE: A normal electrical voltmeter is not suitable for checking the voltage! Special
fence testers exist for this purpose!
If your energiser is working properly, turn it off, unplug it, then proceed to connect your
fence system. Connect the ground connection (6, ground symbol, black terminal nut)
with your grounding post. We recommend using cables with M8 connection eyelets.
The grounding posts should be at least 75 cm long. The better the grounding, the more
effective the electrical pulse will be. Connect the fence connection (7, lightning symbol,
red connection nut) to the fence using a fence connection cable. When assembling the
ground and fence connections, make sure to tighten the connection nuts by hand as
much as possible.
NOTE: To avoid lightning damage, we recommend installing lightning protection
equipment (B), item number 48110.

7. GROUNDING

It is extremely important that your electric fence is properly grounded! This is essential
for the proper functioning of your energiser and to ensure maximum performance. The
grounding should be installed in a damp area with vegetation. Use galvanised metal
posts for the grounding posts. They must have a minimum length of 75 cm (such as item
no. 44219). Dry soil and long fences require additional grounding posts at intervals of
about 2–3 m to improve the connection with the ground. We recommend using the cable
35
41405 | 12 | 2020 | V2