Maintenance And Service; Maintenance And Cleaning - Berner 000088 Originalbetriebsanleitung

OBJ_BUCH-1135-001.book Page 18 Tuesday, January 12, 2010 1:32 PM
Beveling Edges (see figure H)
The V-grooves in the front planer base plate allow
quick and easy beveling of workpiece edges. Depend-
ing on required bevel width, use the corresponding V-
groove. For this, place the planer with the V-groove
onto the edge of the workpiece and guide it along the
edge.
Groove to be
used
none
small
medium
large
Planing with Parallel/Beveling Guide
(see figures D–F)
Mount the parallel guide 21 or beveling guide 24 to
the machine using the corresponding fastening bolt
23. Depending on the application, mount the rebating
depth stop 27 with fastening bolt 26 to the machine.
Loosen locking nut 22 and adjust the desired rebating
width. Retighten locking nut 22.
Adjust the requested rebating depth accordingly with
the rebating depth stop 27.
Carry out the planing procedure several times until the
requested rebating depth is reached. Guide the
planer applying sideward supporting pressure.
Beveling with the Beveling Guide
When beveling rebates
and surfaces, adjust the
required slope angle with
the angle adjustment 25.
Storage Compartment for Planer Blade/Allen
Key
A planer blade 16 and an Allen key 18 can be housed
in the storage compartment 3 as shown in the figure.
To remove the contents in the compartment, com-
pletely pull the storage compartment for the planer
blade/Allen key 3 out of the planer.
3
18 | English

Maintenance and Service

Maintenance and Cleaning

¢ Before any work on the machine itself, pull
the mains plug.
¢ For safe and proper working, always keep
Dimension a
the machine and ventilation slots clean.
(mm)
0 – 5.7
Ensure easy operation of the park rest 28 and clean it
1.9 – 7.6
regularly.
4.7 – 10.3
If the machine should fail despite the care taken in
5.9 – 11.6
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
Berner power tools.
In all correspondence and spare parts orders, please
always include the article number given on the type
plate of the machine.
Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
tools that are no longer usable must be collected sep-
arately and disposed of in an environmentally correct
manner.
Subject to change without notice.
18 16
Do not dispose of power tools into
household waste!
According the European Guideline
2002/96/EC for Waste Electrical and
Electronic Equipment and its imple-
mentation into national right, power
2 609 932 749 • 12.1.10