Bosch AMR 32 F Bedienungsanleitung Seite 13

EURO • Printed in England • BA F016 L69 854 • AMR 32 F • GB • OSW 10/01
AMR 32 F - Buch Seite 2 Freitag, 12. Oktober 2001 10:47 10
Product Specification
AMR 32 F
Part number
Rated power
Tine assembly width
Grassbox capacity
Weight
Protection class
Serial Number
Intended Use
This product is intended for domestic, lawnraking,
scarifying and for the collection of leaves in the lawn
area.
Introduction
This manual gives instructions on the correct as-
sembly and safe use of your machine. It is important
that you read these instructions carefully.
When fully assembled the machine weighs approxi-
mately 9.0 kg. If necessary, obtain assistance to re-
move from packaging.
Take care when carrying the lawnraker to the lawn,
as the tines are sharp.
Delivered Items
Carefully remove the machine from its packaging
and check that you have all the following items:
– Lawnraker with handle assembly
– 2 Bolts (fitted to handle)
– 2 Wing nuts (fitted to handle)
– Grassbox
– Operating instructions
When parts are missing or damaged, please contact your
dealer.
13 • F016 L69 854 • TMS • 08.10.01
Downloaded from www.Manualslib.com
0 600 888 1..
400 W
32 cm
31 l
9 kg
/ II
See serial No 10
(rating plate) on machine
manuals search engine
Operating Controls
1 Handlebar
2 Switch lever
3 Safety button
4 Mains plug**
5 Cable restraint
6 Handle bottom
7 Grassbox
8 Ventilation slots
9 Height of cut lever
10 Serial Number
**Country specific
Not all of the accessories illustrated or described are
included as standard delivery.
For Your Safety
Warning! Switch off, remove plug from mains
before adjusting, cleaning or if cable is cut,
damaged or entangled.
The tines continue to rotate for a few seconds
after the machine is switched off.
Caution – do not touch rotating tines.
Electrical Safety
Your machine is double insulated for safety and re-
quires no earth connection. The operating voltage is
230 V AC, 50 Hz. Only use approved extension ca-
bles. Contact your service agent for details.
Extension cords/leads should only be used if they
comply with H05VV-F or H05RN-F types.
It is recommended for increased electrical safety to
use a Residual Current Device (RCD) with a tripping
current of not more than 30 mA. Always check your
RCD every time you use it.
B
For products not sold in GB: WARNING: For
safety, it is essential that the mains plug 4 attached
to the machine is fitted to the power supply cable 11.
The couplings of connection leads must be protected
against splashes and the coupling sockets on the
leads must be made of rubber or coated with rubber.
Fixing means for the connection leads must be
used.
The connection lead must be inspected for signs of
damage at regular intervals and may only be used if
in perfect condition.
If the supply cord is damaged, it must be replaced by
a Bosch Service Center.
Products sold in GB only: Your mower is fitted with
an approved 13 A (BS 1363/A) electric plug and is
protected by a 13 A fuse (ASTA Approved to
BS 1362).
English - 2