. USAGE SUGGESTION
1. If there isn't enough force pushing down on the bit, the hammer may not be able
2. In winter or in other situations where the temperature of the unit is low (5°C or be-
MAIN UNIT
Maximum Drilling Diameter
Motor Voltage
Speed At No Load (RPM)
Blows Rate Per Minute (BPM)
Weight
(with battery pack: EY9L81)
Overall length
Noise, Vibration
BATTERY PACK
Model No.
Storage battery
Battery
!EY7880(EU).indb 17
!EY7880(EU).indb 17
Downloaded from
www.Manualslib.com
to blow in hammering mode.
This is to prevent the hammering mode from operating with no load. Press down
harder on the bit to engage the hammer and cause it to blow.
Always be sure to press down with enough force when working.
low), the blow of the hammering mode may be weaker than normal at the begin-
ning stage.
This is because the grease becomes stiffer in low temperatures, increasing fric-
tion.
If this should happen, operating hammering mode with no load for approximately
30 seconds and repeat this 3 times. This will restore its blowing power.
. SPECIFICATIONS
Concrete
Steel
Wood
28.8 V DC
Slow Mode
High Mode
Soft Mode
Hard Mode
3.85 kg
319 mm
See the included sheet
voltage
detail spec.
manuals search engine
20 mm
13 mm
27 mm
0 – 500 min
-1
(rpm)
0 – 920 min
(rpm)
-1
0 – 2800 min
(bpm)
-1
0 – 4500 min
(bpm)
-1
EY9L81
Li-ion Battery
DC 28.8 V
3.6 V × 8 cells
- 17 -
EY9L82
3.6 V ×16 cells
2013-11-27 17:03:12
2013-11-27 17:03:12