Operation - Panasonic EY7880 Bedienungsanleitung

1. To mount the bit
1-1. Insert a bit into the mounting hole,
1-2. At the engaged position, push the
2. To dismount the bit
2-1. Depress the chuck cover and pull
Attaching or Removing Bat-
tery pack
Battery holder
The battery pack is designed to be in-
stalled by proceeding two steps for safety.
Make sure the battery pack is installed
properly to the main body before use.
-For installation-
To attach the battery pack, line up the
alignment marks on the body of the
tool and the battery pack, (
insert the battery pack. (
• After you hear the battery pack
NOTE:
!EY7880(EU).indb 7 !EY7880(EU).indb 7
Downloaded from www.Manualslib.com
and turn it slightly to locate an en-
gaged position.
bit as far as it goes. Make sure that
the bit is fixed by pulling it.
SDS PLUS type
shank
the bit.
Battery pack Installation and Removal
clicks when inserting it, keep in-
serting it firmly until the lever locks
it to click once more.
The overheat warning lamp and
the battery low warning lamp will
flash when the battery pack is not
inserted firmly.
manuals search engine
-For removal-
Push the battery holder (
While the battery pack release button
is held up, (
laterally and pull out the pack. (
Battery
holder

. OPERATION

[Main Body]
CAUTION:
When operating the tool by pulling
the trigger, there may be a momen-
tary lag before rotation starts. This
does not signal a malfunction.
This lag occurs as the tool's cir-
cuitry starts up when the trigger
is pulled for the first time after in-
stalling a new battery pack or af-
ter the tool has not been used for
at least 1 minute (or at least 5 min-
utes when the LED is on). Rotation
) and
will start without any lag during sec-
)
ond and subsequent operations.
- 7 -
).
) move the battery pack
)
Release
lever
2013-11-27 17:03:04 2013-11-27 17:03:04