Battery Recycling - Panasonic EY7880 Bedienungsanleitung

• If the tool is operated continuously
• If the tool is used in cold-temper-
• The ambient temperature range
• When charging a cool battery
NOTE:
• In summer or in other situations
(3) LED light
CAUTION:
• The built-in LED light is designed to illu-
• Do not use it as a substitute for a
• LED light turns off when the tool
Caution : DO NOT STARE INTO BEAM.
Use of controls or adjustments or perform-
ance of procedures other than those speci-
fi ed herein may result in hazardous radiation
exposure.
!EY7880(EU).indb 10 !EY7880(EU).indb 10
Downloaded from www.Manualslib.com
under high-load conditions or if it is
used in hot-temperature conditions
(such as during summer), the over-
heating protection feature may ac-
tivate frequently.
ature conditions (such as during
winter) or if it is frequently stopped
during use, the overheating protec-
tion feature may not activate.
is between 0°C (32°F) and 40°C
(104°F). If the battery pack is used
when the battery temperature is
below 0°C (32°F), the tool may fail
to function properly.
pack (below 0°C (32°F)) in a warm
place, leave the battery pack at the
place and wait for more than one
hour to warm up the battery to the
level of the ambient temperature.
where the temperature is high, the
overheating protection feature may
activate and prevent continual use.
Before the use of LED
light, always pull the
power switch once.
Press
light on button.
The light illuminates
with very low current,
and it does not ad-
versely affect the per-
formance of the tool
during use or its bat-
tery capacity.
minate the small work area temporarily.
regular flashlight, since it does not
have enough brightness.
has not been used for 5 minutes.
manuals search engine
[Battery Pack]
For Appropriate Use of Bat tery Pack
Li-ion Battery Pack
• For optimum battery life, store the
Li-ion battery pack following use
without charging it.
• When charging the battery pack,
confirm that the terminals on the
battery charger are free of foreign
substances such as dust and wa-
ter etc. Clean the terminals before
charging the battery pack if any
foreign substances are found on
the terminals.
The life of the battery pack termi-
nals may be affected by foreign sub-
stances such as dust and water etc.
during operation.
• When battery pack is not in use,
keep it away from other metal ob-
jects like: paper clips, coins, keys,
nails, screws, or other small met-
al objects that can make a connec-
tion from one terminal to another.
Shorting the battery terminals togeth-
er may cause sparks, burns or a fire.
• When operating the battery pack, make
sure the work place is well ventilated.
• When the battery pack is removed
from the main unit of the tool, re-
place the battery pack cover imme-
diately in order to prevent dust or dirt
the LED
from contaminating the battery termi-
nals and causing a short circuit.
Battery Pack Life
The rechargeable batteries have a lim-
ited life. If the operation time becomes
extremely short after recharging, re-
place the battery pack with a new one.

Battery Recycling

ATTENTION:
For environmental protection and
recycling of materials, be sure that
it is disposed of at an officially as-
signed location, if there is one in
your country.
- 10 -
2013-11-27 17:03:08 2013-11-27 17:03:08