Control Panel - Panasonic EY7880 Bedienungsanleitung

Installing the Shoulder Strap
CAUTION:
• Install the shoulder strap firmly to
• Check the condition of the strap
• Please wear the shoulder strap se-
1. Pass the strap through the strap
2. Pass the strap through the buckles
Shoulder pad
Follow the instructions below in order
to avoid injury.
• The shoulder strap can be adjust-
• Adjust the shoulder pad to the shoulder.
• Pull the shoulder strap to make sure it is

Control panel

(1) Battery low warning lamp
Off (normal
operation)
Excessive (complete) discharging of Li-
ion batteries shortens their service life
dramatically. The driver includes a battery
!EY7880(EU).indb 9 !EY7880(EU).indb 9
Downloaded from www.Manualslib.com
the main unit of the tool and check
the length of the strap before use.
and do not use if it is cut or torn etc.
There is a risk of injury or damage
if used while improperly installed.
curely on the shoulder.
There is a risk of injury or damage
if it is accidentally dropped.
holders.
and adjust the length.
ed according to the individual.
firmly attached to the main unit of the tool.
(1)
(2)
Flashing (No charge)
Battery protection
feature active.
manuals search engine
protection feature designed to prevent
excessive discharging of the battery pack.
• The battery protection feature ac-
tivates immediately before the bat-
tery loses its charge, causing the
battery low warning lamp to flash.
• If you notice the battery low warn-
ing lamp flashing, charge the bat-
tery pack immediately.
• If it is started with too little battery
power remaining, the tool may stop
operating without the battery low
warning lamp flashing first. This in-
dicates that there is too little bat-
tery power remaining to use the
tool, and the battery pack should
be charged before further use.
• If the tool is subject to a sudden
load during use that causes the
motor to lock up, the overdischarge
prevention sensor may be trig-
gered, and the battery low warn-
ing lamp may flash. The lamp will
stop flashing once you address the
cause of the motor's locking up
and cycle the trigger.
(2) Overheat warning lamp
Off (normal
operation)
To protect the motor or battery, be
(3)
sure to note the following when car-
rying out this operation.
• If the motor or battery becomes hot,
the protection function will be acti-
vated and the motor or battery will
stop operating. The overheat warn-
ing lamp on the control panel illumi-
nates or flashes when this feature is
active.
• If the overheating protection fea-
ture activates, allow the tool to cool
thoroughly (at least 30 minutes).
The tool is ready for use when the
overheat warning lamp goes out.
• Avoid using the tool in a way that
causes the overheating protection
feature to activate repeatedly.
- 9 -
Flashing: Overheat
Indicates operation has
been halted due to motor
or battery overheating.
2013-11-27 17:03:08 2013-11-27 17:03:08