Panasonic EY7880 Bedienungsanleitung Seite 11

Recommendations for use
Be sure to use the Pack cover
• When the battery pack is not being
used, store the battery in a way that for-
eign substances such as dust and wa-
ter etc. do not contaminate the termi-
nals. Be sure to attach the battery pack
cover to protect the battery terminals.
• When charging the battery pack, con-
firm that the terminals on the battery
charger are free of foreign substanc-
es such as dust and water etc. Clean
the terminals before charging the bat-
tery pack if any foreign substances
are found on the terminals.
The life of the battery pack terminals
may be affected by foreign substanc-
es such as dust and water etc. during
operation.
CAUTION:
To protect the motor or battery, be sure
to note the following when carrying out
this operation.
• If the motor and battery become hot, the
protection function will be activated and
the motor and battery will stop operating.
For safe use
• The battery pack is designed to be in-
stalled by proceeding two steps for
safety. Make sure the battery pack is in-
stalled properly to the main unit before
use.
• If the battery pack is not connected firm-
ly when the switch is switched on, the
overheat warning lamp and the battery
low warning lamp will flash to indicate
that safe operation is not possible, and
the main unit will not rotate normally.
Connect the battery pack into the unit of
the tool until the red or yellow label dis-
appears.
!EY7880(EU).indb 11 !EY7880(EU).indb 11
Downloaded from www.Manualslib.com
Pack cover
Terminals
Label
manuals search engine
[Battery Charger]
Charging
CAUTION:
• The charger is designed to operate
on standard domestic electrical
power only as stated in the rating
plate. Charge only on the voltage
indicated on the rating plate of unit.
e.g.230V / 50Hz.
• Do not attempt to use it on any
other voltage or frequency rating!
• If the temperature of the battery pack
falls approximately below −10°C
(14°F), charging will automatically
stop to prevent degradation of the
battery.
• Do not charge the battery pack whose
temperature is below 0°C (32°F).
• When charging a cool battery
pack (below 0°C (32°F)) in a warm
place, leave the battery pack at the
place and wait for more than one
hour to warm up the battery to the
level of the ambient temperature.
Otherwise battery pack may not be
fully charged.
• Cool down the charger when charg-
ing more than two battery packs
consecutively.
• Do not insert your fingers into con-
tact hole, when holding charger or
any other occasions.
CAUTION:
To prevent the risk of fire or dam-
age to the battery charger.
• Do not cover vent holes on the
charger and the battery pack.
• Unplug the charger when not in use.
NOTE:
Your battery pack is not fully
charged at the time of purchase. Be
sure to charge the battery before
use.
- 11 -
2013-11-27 17:03:09 2013-11-27 17:03:09