Operating; Start/Stop; Workflow; Free Blocked Log - Zipper Maschinen ZI-WP700TN Betriebsanleitung

13.2 Operating

13.2.1 Start/Stop

To start the machine, press the green button ˝I˝.
To stop, press the red button ˝O˝.

13.2.2 Workflow

1. Switch on the machine.
2. Open the upper protective cover.
3. Position the cut material on the completely extended rocker unit in the cut material
support.
4. Grasp the handle on the left side of the carriage and slide it towards the saw blade
cover.
→ The hooks in the rocker unit protect the workpiece from twisting.
5. Continue pressing with even force until the cut material has been cut.
6. After the cut, move the rocker all the way back again.
7. If necessary, reposition the cut material and repeat steps 4 to 6 until the work is
finished.
8. Switch off the machine after work.
9. Wait until the machine stops.
10. Disconnect the power plug and clean the unit if necessary.

13.2.3 Free blocked log

If the saw blade is blocked, proceed as follows:
1. Switch off the device immediately!
2. Wait until the saw comes to a standstill
3. Pull out power plug.
4. Carefully remove the blocked log from the machine.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-WP700TN
OPERATION
23