Operation; Work Prior To Start-Up - Zipper Maschinen ZI-WP700TN Betriebsanleitung

13

OPERATION

13.1 Work prior to start-up

 After having checked the direction of rotation of the motor, make sure that the saw
blade is firmly seated, in perfect condition, sharpened and guaranteed to run
smoothly.
 Make sure that the rocker unit is fully extended before each use. Otherwise there is
an increased risk of kickback.
 When cutting material, pay attention to foreign objects such as wires, nails, etc. as
well as irregularities in the material, such as knots.
 Check that the moving parts are working properly and are not jammed.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-WP700TN
W A R N I N G
Check the direction of rotation of the motor! Switch the ma-
chine on briefly. Correct running direction: see arrow on the saw
blade cover or the saw blade.
If the running direction is set incorrectly, switch the machine off
immediately – danger of injury by loosening the saw blade.
Change the direction of rotation by inserting a screwdriver into
the slot provided for this purpose in the plug and adjusting the
correct direction of rotation with slight pressure by moving it to
the left or right (turn the phase inverter by 180°).
Before you start sawing, you must loosen
the transport lock - see picture on the
left!
OPERATION
22