Operation - Aerial AD 520 Serie Betriebsanleitung

5. Run the end of the hose into a drain or
a suitable container.
Electrical connection
Procedure
1. Make sure that the supply voltage is
the same as the connection voltage in
the technical data.
2. Provide an adequate fuse for the sock-
et and the power supply.
3. Install an earth leakage circuit breaker
in damp rooms and building sites.
4. Make sure that the mains plug is suita-
ble for the socket of the building.
5. Make sure that the socket used is
earthed.
6. Plug the mains plug into the socket.
9

Operation

Setting the language
Procedure
1. Make sure that the dehumidifier is
switched off and the mains plug is
pulled out.
2. Plug in the mains plug.
3. Hold the key down for 5 seconds.
4. The display will show the current lan-
guage.
5. Set the desired language using the
arrow keys
6. Wait 3 seconds until the selected lan-
guage stops flashing.
The language cannot be changed during
operation.
Dehumidifying the room
NOTE: Allow the dehumidifier to rest in its
final position for approx. 15 minutes before
starting up, after transport and after pro-
longed storage.
18
.
Procedure
1. Make sure that the condensate water
can drain off through a discharge hose
or into the basin.
2. Press the key.
"Start" will flash in the display. The dehu-
midifier will start operating. Operation is
not possible when "Stop" or "Start" is flash-
ing.
3. Set the desired humidity using the
arrow keys
will only start if the actual room humidi-
ty is higher than the target room hu-
midity.
4. Select the fan level. To do this, press
the key.
The dehumidifier runs until the target room
humidity has been reached or the basin is
full, then it will stop running.
Emptying the basin
The display indicates "Watertank Full".
Procedure
1. Empty the basin.
Humidity reached
The display indicates "Humidity O.K.". The
set target room humidity is lower than
actual room humidity.
Procedure
If necessary, reduce the target room hu-
midity or set to continuous operation (con-
tinuous operation 31% to 70%).
AD 810: Pumping out water
The condensate water can be pumped
away if necessary as follows:
. The dehumidifier