Assembly Steps; Operation; Operation Instructions; Inserting/Replacing The Battery - Zipper Maschinen ZI-EBM40V-AKKU Betriebsanleitung

12.1

Assembly steps

13

OPERATION

The batteries are not fully charged on delivery. Prior to initial operation, charge
the batteries fully. See user manual of the battery charger.
13.1

Operation instructions

Device to be operated in a perfect state only. Inspect the device visually every time it is to be used.
Check in particular the safety equipment, electrical controls, electric cables and screwed connection
for damage and if tightened properly. Replace any damaged parts before operating the device.
Unplug battery before all maintenance and settings and cleanings!
Never remove the battery while the machine is running.
If the power tool is damaged or vibrates unusually, it must be repaired by a
service centre before it is used again.

Inserting/replacing the battery:

 Charging the battery as described in the user manual
of the charger.
 Press the charged battery into the power tool until it
clicks into place.
 To remove, press the release button (1.) and pull out
the battery (2.).
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-EBM40V-AKKU
Fix the mixer (3) or auger (2) to the machine with
screws (1).
To do this, place the respective tool (2 or 3) on the
machine, align the holes on the drive shaft of the
machine and the tool, push the screws through and
tighten them in the thread of the tool. For
disassembly loosen the screw again and remove the
tool.
NOTICE
WARNING
OPERATION
19