ECOVACS CH1918 Bedienungsanleitung Seite 19

4 Troubleshooting
No. Problem
DEEBOT does not start auto-emptying
1
after returning to the Auto-Empty Station.
DEEBOT fails to auto-empty the Dust
2
Bin.
3 There is debris in the Dust Container.
DEEBOT leaks dust or debris while
4
cleaning.
5 The Base is dirty.
Possible Cause
The Dust Container Lid is not closed.
The Dust Bag is not installed to the Auto-Empty Station.
Manually move DEEBOT to the Auto-Empty Station will not
trigger Auto-Emptying.
DEEBOT returns to the Auto-Emptying Station running
Video Manager in the App.
Do Not Disturb mode is enabled in ECOVACS HOME App.
The Dust Bag is full.
If the possible causes are excluded, it might be a
component malfunction.
The Auto-Empty Dust Bin is not installed.
The Dust Bag is full.
The Auto-Empty Outlets on the Auto-Empty Dust Bin is
stuck by debris.
Dust Evacuation Tube is blocked.
Fine particles are absorbed inside the Dust Container
through the Dust Bag.
The Dust Bag is damaged.
The Auto-Empty Outlets are stuck by debris.
Main Brush has debris on it and requires cleaning.
Solution
Close the Dust Container Lid.
Install the Dust Bag and close the Dust Container Lid.
In order to make sure DEEBOT starts auto-emptying
successfully, avoid picking up and moving the Auto-
Empty Station during the cleaning.
This is normal.
This is normal. Disable Do Not Disturb mode in the App,
or start auto-emptying manually.
Replace the Dust Bag and close the Dust Container Lid.
Please contact customer service.
Please install the Auto-Empty Dust Bin with two Auto-
Empty Outlets on the bottom.
Replace the Dust Bag and close the Dust Container Lid.
Uninstall the Auto-Empty Dust Bin and clean the debris
on the Auto-Empty Outlets.
Clean the Dust Evacuation Tube.
Clean the Dust Container Lid and inner wall.
Check the Dust Bag and replace it.
Uninstall the Auto-Empty Dust Bin and clear the debris.
Clean the Main Brush.
19
EN