Maintenance; Maintenance Schedule - Husqvarna LC 137i Bedienungsanweisung

High load function
When the product cuts long or wet grass, the motor
automatically increases rpm. The motor goes back to
standard mode when high load is not necessary.
To stop the product
WARNING:
before you let the product out of view.
1. Release the motor brake handle to stop the motor.
(Fig. 38)
2. Open the battery lid and turn the safety key to 0.
(Fig. 39)
3. To remove the battery, push the 2 release buttons
and pull out the battery. (Fig. 40)
4. Charge the battery if it is weak. For more
information, refer to
17 .
To get a good result
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
Do a general inspection.
Clean the product.
Do a check of the start inhibitor. *
Make sure that the safety devices on the product are not defective. *
Examine the cutting equipment.
Examine the cutting cover. *
Do a check of the motor brake handle. *
Examine the battery for damage.
Do a check of the battery charge.
18
Turn the safety key to 0
To charge the battery on page
Before you do
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
To cut grass without a grass catcher or
mulch plug attached
• Lift up the rear cover and remove the grass catcher.
• If a mulch plug and a mulch blade are attached,
remove them.
• Close the rear cover before you operate the product.
When you operate the product, the cut grass discharges
below the rear cover.

Maintenance

service agent, speak to them for information about the
nearest service agent.

Maintenance schedule

The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * see instructions in
Maintenance on page 18 .
Each use Monthly
X
X
X
X
X
X
X
X
X
1574 - 002 - 08.12.2020
Each
season