Sage SDC400 Kurzanleitung Seite 16

P R O B L EM
L C D s h o w s ' F I L L
T A NK ' w h e n
t h e r e i s w a t e r
i n t h e t a n k
B r e w d o e s n ' t
s t a r t
S h o w e r h e a d
f a l l s o u t
The mesh filter
i n t h e w a t e r
t a n k l o o s e n s
and floats
C a r a f e d r i p s t o p
s t a y s d o w n
U n i t p r o d u c e s
e x c e s s i v e s t e a m
w h i l e b r e w i n g o r
r u n s f o r e x t e n d e d
p e r i o d s w i t h o n l y
s t e a m o u t p u t
' D ES C A L E' o n
L C D s c r e e n
(flashing)
U n i t s h o w s
" t o o h o t "
LCD flashes
F I L T ER
1 6
P O S S I B L E C A U S E
• Check that the unit is not in direct
sunlight or direct bright lighting.
• There is no water in the water tank.
• Each brewing mode has different
water amount limits, and it does
not brew when the amount
is beyond the limit.
• The showerhead may loosen
and fall out from time to time if not
inserted or tightened correctly.
• Mesh filter is not inserted
or tightened correctly.
• The drip stop is stuck.
• Brewing performance is affected
by scale accumulated by
hard water.
• Brewing temperature profile is not
properly set.
• Brewing performance is affected
by scale accumulated by
hard water.
• Unit has been run too many times
back to back and the components
are overheated.
• Water filter needs to be replaced.
W H A T T O D O
• Move unit away from the light source.
• Check that the water tank is filled.
• Check the water amount limits for
each mode.
• Please wash the showerhead ring
and seal and re‑insert.
• Call Sage Consumer Support.
®
• Pull the drip stop back up.
• Clean the drip stop for any foreign objects
of coffee grinds or stains.
• If the problem persists and drip stop does
not return to top position please call Sage
Consumer Support.
• Descale the unit.
• Call Sage Consumer Support if problem
®
persists.
• Descale the unit by following the
instructions under Descaling in the Care
& Cleaning section of this manual.
• Let unit rest for at least 20mins before
starting another cycle.
• Replace water filter following instructions in
'Care and Cleaning' section.
Navigate to SETTINGS menu and set YES
to NEW FILTER.
®