BATTERIES
Tabcat Handheld:
If the Tabcat does not power up or lights are faint, replace
the battery using 1 x CR2032 placing in the battery
compartment '+' side up. Battery compartment can be
found on the back at the bottom. Slide down to open.
To change the batteries in a Tag:
Remove rubber band going around Tag.
Use the flat tool included, or small screwdriver,
and insert into small space on the side of the tag
opposite where the lanyard hole is.
Twist flat tool and tag will pop open.
• Replace battery with new CR2032 battery,
keeping the plus side face up.
• Replace the lid by lining up the lanyard hole and
pressing shut.
• If the batteries are correctly inserted the Tag will
beep when case is closed.
To test the batteries, open then shut the lid. If the Tag
does not beep and flash – replace the batteries.
GENERAL CARE
The Tabcat Tags have been designed to be water resistant but not waterproof.
(We recommend using with splashproof case provided for extra protection.)
• Never clean with water, detergent or cleaning agent – use a clean, dry cloth.
• The Tabcat Handheld and Tags' operational temperature is between 0˚C to + 55˚C.
Storage temperature is between -10˚C and +60˚C.
www.mytabcat.com
Downloaded from
www.Manualslib.com
manuals search engine
Lanyard hole
Insert here
9