Batteries; General Care - Loc8tor Pet Bedienungsanleitung

BATTERIES

Loc8tor Handheld:
If the Loc8tor does not power up or lights are faint
replace the battery using 1 x CR2032 or equivalent
placing in the battery compartment + side up.
Battery compartment can be found on the back at
the bottom. Slide down to open.
To change the batteries in a Tag:
Put your thumbnail or a flat tool at the end of the Tag,
by the lanyard hole, into the split line (line going around
the middle of the Tag).
Keeping your thumbnail / flat tool in the split line move
it around to the middle of the long side. The Tag will
pop open.
• Replace with SR54 (silver oxide) 1.5v button cells
or equivalent to provide best battery life, keeping
the plus side face up nearest the lanyard hole.
• Replace the lid by putting one side in first then
pushing shut.
• If the batteries are correctly inserted the Tag will
beep when case is closed.
To test the batteries, open then shut the lid by following
the above steps. If the Tag does not beep and flash –
replace the batteries.

GENERAL CARE

• The Loc8tor Handheld and Tags have not been designed to be waterproof. Please take care not to get wet.
(We recommend using our Splashproof or PetSplash Tag casing for extra protection.)
• Never clean with water, detergent or cleaning agent – use a clean, dry cloth.
• The Loc8tor Handheld and Tags' operational temperature is between 0˚C to + 55˚C.
Storage temperature is between -10˚C and +60˚C.
8
www.loc8tor.co.uk www.loc8tor.com