Locating Tips / Range Guidelines; Batteries; General Care - Loc8tor Tabcat Bedienungsanleitung

LOCATING TIPS
• Place the Tag on a surface and practice locating it a few times to get a feel for how it works.
• If you are ever unsure of which direction to go in, slowly repeat a full 360° circle and then go in the direction
with the strongest signal strength.
• Strongest signal is displayed when the Tabcat is pointing directly at the Tag. Try pointing the Tabcat up and
down as the Tag could be upstairs or downstairs.
• If you are close to a wall whilst getting a strong signal check the room next door.
• Try pressing the volume button on the Tabcat when you are close in order to mute and listen out for Tag beeps.
• If no signal is displayed try moving position to a different area and repeat the process.
For more tips on finding your cat or how to get the most from your Tabcat visit us at www.mytabcat.com/tips
RANGE GUIDELINES
Range will vary greatly depending on where the Tag is used and what it's attached to. If higher up and with a clear
line of sight (such as a cat in a tree), items can be found in excess of 122m/400feet. If locating through doors and
walls range will be significantly less. Actual range may differ significantly as performance is affected by type of
application and environment it's used in. If no signal is picked up and displayed just walk whilst locating. As soon as
you're in range Tabcat will pick up the signal and guide you in.
8

BATTERIES

Tabcat Handheld:
If the Tabcat does not power up or lights are faint, replace
the battery using 1 x CR2032 placing in the battery
compartment '+' side up. Battery compartment can be
found on the back at the bottom. Slide down to open.
To change the batteries in a Tag:
Remove rubber band going around Tag.
Use the flat tool included, or small screwdriver,
and insert into small space on the side of the tag
opposite where the lanyard hole is.
Twist flat tool and tag will pop open.
• Replace battery with new CR2032 battery,
• Replace the lid by lining up the lanyard hole and
• If the batteries are correctly inserted the Tag will
To test the batteries, open then shut the lid. If the Tag
does not beep and flash – replace the batteries.

GENERAL CARE

The Tabcat Tags have been designed to be water resistant but not waterproof.
(We recommend using with splashproof case provided for extra protection.)
• Never clean with water, detergent or cleaning agent – use a clean, dry cloth.
• The Tabcat Handheld and Tags' operational temperature is between 0˚C to + 55˚C.
Storage temperature is between -10˚C and +60˚C.
www.mytabcat.com www.mytabcat.com
keeping the plus side face up.
pressing shut.
beep when case is closed.
Lanyard hole
Insert here
9