Getting Started - Loc8tor Tabcat Safe & Found Bedienungsanleitung

GETTING STARTED

Your Tabcat could not be easier to setup or use. Follow these steps and you'll be able to start tracking down your
tagged cat or kitten in no time at all.
1. ACTIVATE HANDSET BATTERY
Pull out the strip on the back of the handset to activate battery. It will beep and all
the lights will flash – It is now ON.*
* After approx. 45 seconds left idle your Tabcat will turn itself off.
2. REGISTER A TAG
• Homing Tag is supplied ready to be registered.
• Place Tag you wish to register next to the handset making sure all other Tags have been moved away.
• Make sure the Tabcat handset is switched on (red status light will flash when ON).
• Select one of the buttons on the front of the Tabcat to assign the Tag to.
Hold the button down for 3 seconds. The Tabcat will beep. Release button.
• Tabcat will now start registration and status light will flash rapidly.
Tag will complete registration process.
• Once registered Tag and Tabcat will beep and flash once.
• Repeat process for up to 4 Tags, assigning each Tag to a different button.
Each of the four Tags when being located will beep differently to help identification.
3. ATTACH TAG TO COLLAR
Insert the Tag in to the splashproof case by pushing it through
the hole in the back. Then attach directly onto your pets collar by
threading collar through the two holes on the back of the case.
www.mytabcat.com
Downloaded from www.Manualslib.com manuals search engine
Thread collar
through holes
5