Maintenance - Powers Fasteners F16 Betriebsanleitung

BradNailer F16 Op Man_NEW.qxd
MODEL F16
The headlights also function as a low battery indicator and a
jammed nail indicator. For a further explanation of these
functionalities, refer to the relating instructions in this manual.
INSTRUCTIONS FOR USE
PRIOR TO OPERATION:
• Make sure your battery pack is (fully) charged.
PREPARING THE TOOL (FIG I, PAGE 7)
• Remove all Powers nailsfrom the magazine.
• Lock the nail pusher (15) in the back position.
• Check if the contact trip (5) and nail pusher (15) can move
freely.
• Reload the Powers nails to the magazine.
ACTUATING THE TOOL (FIG A, PAGE 3)
The tool can be operated using one of two modes: sequential
action mode or bump action mode.
SEQUENTIAL ACTION MODE
The sequential action mode is used for intermittent nailing when
very careful and accurate placement is desired.
• Select the sequential action mode.
• Release the contact trip lock (2).
• Push the contact trip (5) against the work surface.
• Pull the trigger (1) to actuate the tool.
Each trigger pull with the contact trip pushed against the work
surface will drive one nail.
BUMP ACTION
The bump action mode is used for rapid nailing on flat, stationary
surfaces.
• Release the contact trip lock (2).
• Select the bump action mode.
• To drive a single nail: Operate the tool as described for
sequential action.
• To drive several nails: Pull the trigger (1) first, and then push
the contact trip (5) repeatedly against the work surface.
Downloaded from www.Manualslib.com
18/8/08
The headlights are intended for lighting the
immediate work surface. Do not use the
headlights as the only light source.
• Always observe the safety instructions and
applicable regulations.
Do not use the tool if the contact trip or nail
pusher cannot move freely.
manuals search engine
1:39 PM Page 15
Do not keep the trigger depressed when the
tool is not in use. Keep the trigger lock-off
switch rotated to the right to prevent accidental
actuation when the tool is not in use.
CLEARING A JAMMED NAIL (FIG A, PAGE 3 & J, PAGE 7)
If a nail becomes jammed in the nosepiece, the headlights (4) will
blink continuously.
• Remove the battery pack (9).
• Engage the contact trip lock (2).
• Remove all nails from the magazine (6).
• Release the latch (18) on top of the nosepiece.
• Retract the barrel (19) so the jammed nail is exposed.
• Remove the nail, using pliers if necessary.
• If the driver blade is in the down position, insert a screwdriver
into the nosepiece and push the blade back in position.
• Lower the barrel back in place.
• Re-engage the latch.
If nails become jammed in the nosepiece
frequently, have the tool serviced by an
authorised Powers service centre.
OPTIONAL ACCESSORIES
Since accessories, other than those offered by
Powers, have not been tested with this product,
use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only
Powers, recommended accessories should be
used with this product.
Consult your dealer for further information on the appropriate
accessories.

MAINTENANCE

Your Powers power tool has been designed to operate over a long
period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and regular
cleaning.
LUBRICATION
This tool requires no lubrication.
Do not lubricate the tool as it will damage the
internal parts.
15