Supplying Power; Battery Recharging - Epson TM-P60 Bedienungsanleitung

English

Supplying Power

You can supply power through the battery pack packaged with the printer or the
AC adapter PS-10 (Model: DA-42Y12). See illustration
WARNING:
Be sure to use the battery LIP-2500 that came with the printer. Using a battery
other than the one specified may cause fire, explosion, leakage, overheating
or other damage.
CAUTION:
There is risk of explosion if the battery is replaced by an incorrect type. Dispose
of used batteries according to the instructions.
1.
2.
3.

Battery Recharging

WARNING:
Be sure to charge the battery that came with the printer. Using a battery other
than the one specified may cause fire, explosion, leakage, overheating or
other damage.
Note:
The battery can be charged only when the temperature is 0 ~ 40°C (32 ~ 104°F).
1.
2.
3.
Recharging will take approximately 5 hours with the AC adapter, or if you use the
fast recharger (option), recharging will take approximately 2.5 hours. For detailed
information for the fast recharger (option), see its instructions. The times
described above are the times taken to charge a battery pack that is fully
discharged.
Switching Issuing Mode
The issuing mode can be switched between the label continuous issuing mode and
the label peeler issuing mode by folding the peeler holder under the peeler cover.
Installing or Replacing Roll Paper
CAUTION:
Be sure to use roll paper that meets the specifications.
Note:
Do not use paper rolls that have the paper glued to the core.
1.
2.
(When using the label continuous issuing mode)
3.
8 TM-P60 with Peeler User's Manual
Downloaded from www.Manualslib.com
Slide the battery cover to open it.
Install or remove the battery and close the cover.
If you use the AC adapter, plug in the connector as shown in illustration
Be sure that the printer is turned off and the battery to be charged is installed.
Connect the AC adapter to the printer (see illustration
Recharging will now be started.
Press the open button to open the roll paper cover and the peeler cover.
D
See illustration .
Remove the used roll paper core if there is one.
Fold the peeler holder under the peeler cover. This covers the label peeler
detector. See illustration
manuals search engine
E
.
C
.
A
).
A
.