Herunterladen Inhalt Inhalt Diese Seite drucken

Epson TM-P60 Bedienungsanleitung Seite 15

With peeler
Vorschau ausblenden Andere Handbücher für TM-P60:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 21
(When using the label peeler issuing mode)
3.
(When installing the label paper horizontally)
4.
Note:
Note the direction the paper comes off the roll. See illustration
(When installing the label paper vertically)
4.
5.
6.
Note:
Note the direction the paper comes off the roll.
7.
8.
9.
Note:
Removing the issued label enables the label peeler detector to detect a PAPER END and the
printer to issue the next label.
If the first label is not removed when using the label peeler issuing mode, the thickness of
the label and the backing paper overloads the peeler holder, possibly stopping the paper feed
motor.
When closing the peeler cover, make sure to close it firmly, pressing both ends.
See illustration
When tearing the backing paper, pull it in the direction of the arrow shown in the
illustration
paper jam.
When the label is completely fed to the peeling position, the printer goes in the label
removal waiting state, so remove the label.
When the label peeler detector detects the paper at the power on, the printer goes in the
label removal waiting state and the ERROR LED comes on. Be sure to remove the label
before powering off the printer. Otherwise, the printer goes into the label removal waiting
state when it is powered on again.
Buzzer
The factory default is set to On (buzzer sounds) to indicate the following:
Downloaded from
www.Manualslib.com
Peel off the first label, and press the peeler change over lever to lift the peeler
holder.
Set the new roll paper on the inside of the roll paper cover.
Set the new roll paper in the inside of the roll paper cover. See
G
illustration
.
Pull the leading edge of the roll paper. See
Align the left edge of the roll paper with the edge of the cover. See
G
illustration
.
Pull the leading edge of the roll paper. See illustration
Close the roll paper cover.
Close the peeler cover.
H
.
I
as you tear it. Otherwise, the backing paper may move to one side, causing a
Remaining battery charge is not adequate
Host disconnection
Roll paper end
Error
Transmission of status information
manuals search engine
F
.
G
in illustration
F
.
TM-P60 with Peeler User's Manual 9
English
in
.
in

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis