Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION
1 POSITIONING AND MAINTENANCE
The machine must only be installed by qualified and authorised staff.
The machine must only be used for the purpose of dividing or dividing and rounding dough.
The warranty is not valid if changes are made without the manufacturer's authorisation and/or
if non-original spare parts are used. Use of non-original spare parts can damage the machine
and/or harm the operator.
The machine must be positioned on a solid and regular floor. The machine is very stable.
2 ELECTRICAL CONNECTION
A qualified technician should carry out installation and an electrician should connect the
machine to the power supply system. Firstly check the voltage and the connection phases are
equal to those of the machine (see identification plate). If this is not the case, contact the
retailer.
Check the rotation direction of the motor on the machine. Turn the main knob to position I-ON.
Close the guard casing and run an "empty" work cycle. Check if the shaping plate oscillates. If
this is not the case, an electrician must invert the phases, i.e. he must invert the two cables in
the power plug to change the rotation direction of the motor.
3 DISPOSAL OF THE MACHINE
When you want to dispose of an entire machine, parts or just the packaging, you must comply
with the waste disposal rules. Specifications regarding the material on the various parts can be
obtained from the manufacturer. See WEEE.
4 PLACING MACHINE OUT OF SERVICE
Switch off the machine by bringing the main switch to 0-OFF and subsequently protecting the
machine from external factors and leave it in a dry and enclosed location.
UK/2
Werbung
