Configuration Of The Big 10 Router Via Inbuilt Graphical User Interface (Gui) - Elcon nect next BIG 10 Kurzbedienungsanleitung

3 Configuration of the BIG 10 router via inbuilt graphical user interface
(GUI)
The BIG 10 can easily be configured using its in-built graphical user interface. This can be
done using a standard Internet browser (Firefox, Internet Explorer, Safari), which are availa-
ble at most modern computer today.
To access the Web-GUI proceed as follows:
1. Make sure, that the network settings of your computer allow the automatic IP-address
2. Connect your computer with the LCT interface of the BIG 10 using a standard Ether-
3. After connecting the device, the computer will be assigned by an IP-address automati-
It is as well possible to use a static IP-address. For this apply your computer the following
data:
Address Range
Subnet Mask
Gateway Address
Open now your Web-Browser and type the following in the address field:
http://192.168.1.1
Note
The following login window appears after successful connect:
The login is allowed for the following user:
 The „normal user" can mainly access status information of the device.
 The „administrative user" can access all settings of the device.
30
Downloaded from www.Manualslib.com
assignment. Please ask you network administrator for further details.
net cable.
cally.
Pre-Settings
192.168.1.2 bis 255
255.255.255.0
192.168.1.1
Make sure, that your proxy settings are switched off or set correctly.
manuals search engine
Figure 5: Login window
BIG 10 Bridge
User-Settings
Version: 2013/04/15