Cable Connection - Elcon nect next BIG 10 Kurzbedienungsanleitung

BIG 10 Bridge
LED signalling
The modem has 6 LEDs which signal the data transfer activities.
Designation
LED
Start-up
Power ON
Initialisation
Ready
SHDSL
Down (ready) /
Down (idle)
G.hs transfer
G.hs Line-probing
Training
Data Mode
PCS sync
PCS sync
ETH-PORTS
disconnect
LCT-Link
LAN-Link
Fehleranzeigen
1 Link down
(PAF4)
all Links down
internal error
Software update
Download
Flash
programming
2.5
1. Connect the WAN-interface of the BIG 10 with the access port of your network opera-
2. Link the BIG 10 with the network interface card of the PC. For this, use an Ethernet
Version: 2013/04/15
Downloaded from www.Manualslib.com
Operating status
Power Alarm
(yellow) (red)
ON
ON flashes at
1Hz
ON
flashes at
ON
1Hz or ON
ON flashes at
1Hz or ON
ON flashes at
1Hz or ON
ON flashes at
1Hz or ON
ON flashes at
1Hz or ON
ON flashes at
1Hz or ON
ON flashes at
1Hz or ON
ON
ON
ON ON
ON
ON
ON
ON

Cable connection

tor, using a UTP (Unshielded Twisted Pair) CAT5 cable or better, to ensure optimal
transmission parameters. The cable contact assignment at the socket can be requested
from your network provider.
cable and connect it to one of the „LAN"-marked RJ45-sockets on the BIG 10 and to
the RJ45-socket of the network interface card (see the related instructions).
manuals search engine
LINK (WAN) LAN
LINK Status LAN
(green) (yellow) (green)
ON
ON OFF
flashing
at 2 s
flashing
flashes at
1Hz
flashes at
2Hz
ON OFF
ON ON
OFF
ON
ON
ON ON
ON ON
flashes flashes flashes
all LED ON and are switched off in clock-
wise direction
Remarks/
Result
Status
(yellow)
The other LEDs are flashing 3 times
prior to this < 15 s Alarm ON
min 1 SHDSL-Line sync.
Alarm LED shines if min. one SHDSL-
Line was active
Number of flash pulses shows first
activating Line
short interruption of the shining LED
min 1 SHDSL-Line in Status Training
min 1 SHDSL-Line in Data mode
all SHDSL-Lines of the EFM-Bonding
Group are synchronized
min. 1 SHDSL-Line of the EFM-
Bonding Group is synchronized
OFF
LAN-LED flashes upon data transfer
LAN-LED flashes upon data transfer
no dedicated fault identification im-
plemented
Initial situation
flashes
27