Safety Precautions - Elcon nect next BIG 10 Kurzbedienungsanleitung

BIG 10 Bridge

Safety precautions

 Please read carefully the warnings and safety precautions in this operating manual be-
 The BIG 10 has been manufactured according to state-of-the-art technology and com-
 Do not use sharp-edged tools for unpacking the device: they could damage cables or
 The device and its accessories (cable etc.) shall be operated only in faultless condition,
 Only authorized personnel are allowed to open the enclosure and to carry out interven-
 Warning: Dangerous electric voltage! Before opening the modem, remove the plug-in
 Refrain from interventions in the modem and its parts during thunderstorms (in partic-
 When connecting the modem, pay attention to comply with the required mains voltage.
 The device has no separate switch for interrupting the power supply, since it has been
 Lay the power supply and connection cables in a way to prevent accidents (such as
 The device shall be operated only between 0°C and +45°C.
 Protect the device from direct sun radiation and extreme humidity.
 When the device is taken from a cold environment into a warmer one, it may be be-
 Connect to the modem interfaces only such terminal devices which meet the safety re-
 The terminal devices shall have appropriate connectors; otherwise adequate adapters
 Connected equipment shall only be operated at the corresponding interfaces that have
 Pay attention to the instructions on installation and safety and comply with them.
Version: 2013/04/15
Downloaded from www.Manualslib.com
fore you start installation of your BIG 10. These instructions enable you to use the full
functionality of the device and to avoid damage which may result from improper use
(fire, electric shock, injuries etc.). Keep this manual at a safe place.
plies with the generally accepted safety standards.
the enclosure.
while strictly observing these operating instructions.
tions in the device. Please observe the protective measures with respect to electrostatic
discharge as per DIN 100 015. Manipulations on the modem or attached parts (cables
etc.) other than those described in this manual are not allowed.
power supply module and disconnect the cables from the interfaces!
ular, avoid plugging and unplugging of cables).
(→ Technical data)! The device shall not be installed farther than 1.5 m from the socket.
designed for continuous operation. So make sure the plug-in power supply module is
always easily accessible.
tripping over the cables).
dewed. In this case the equipment must not be put into operation. So please wait until
the modem is dry again.
quirements acc. to EN 60950-1 and which are labelled with the CE symbol.
have to be used.
been designed for them.
manuals search engine
1