I Remote Control - Panasonic CS-V12CTP Handbuch

NAME OF EACH PART

I Remote Control

1
2
AUT AUTO
HEAT HEA
COOL COOL
H
DR DRY OFF OFF ON ON
A
3
TEMP
MODE SLEEP FAN SPEED
4
5
A B
6
TIMER
7
SELECT SET/CANCEL
G Remote Control Signal.
• Make sure it is not obstructed.
• Maximum distance : 10 m.
• Signal received sound.
One short beep or one long beep.
G Notes for Remote Control.
• Do not throw or drop.
• Do not get it wet.
• Certain type of fluorescent lamps may affect
signal reception. Consult your dealer.
G Do not place the remote control in a location exposed
to direct sunlight, or next to a heating unit, or other
heat source.
Downloaded from www.Manualslib.com
1 Signal Transmitter
2 Operation Display
FAN AN
SPEED SPEED
AUTO
COOL COOL
H
OFF OFF ON ON
B
OFF/ON
8
9
AUTO
!
AUTO AUT
"
AIR SWING HEA HEAT
#
COOL COOL
MANUAL
DRY DR
$
RESET
3 Room Temperature Setting Button
(Illuminating button)
4 Operation Mode Selection Button
5 Sleep Mode Operation Button
(Illuminating button)
6 Timer Setting Button
7 Timer Selection Button
8 OFF/ON Button
(Illuminating button)
9 Fan Speed Selection Button
0 Auto Airflow Direction Button
! Timer Set/Cancel Button
@ Manual Airflow Direction Selection Button
# Reset Point
(Press with fine-tipped object to clear the memory)
manuals search engine
Cooling Model
FAN AN
SPEED SPEED
DRY
H H
FAN
OFF OFF ON ON OFF OFF ON ON
A B
Heat Pump Model
FAN
SPEED
H H
OFF ON OFF ON
A B
G How to Insert the Batteries
1
1
Gently press the place marked OPEN and slide
the cover towards you.
2
Insert the batteries
– Be sure the direction is correct.
G About the batteries
• Can be used for approximately one year.
G Observe the following when replacing the batteries
• Replace with new batteries of the same type.
• Do not use rechargeable batteries (Ni-Cd).
• Remove the batteries if the unit is not going to be
used for a long period.
G Proper way to operate the remote control in the
case of ceiling/wall mounting.
• Operate the remote control in parallel with the floor.
(See the figure below)
(Fig. 1) Horizontal Level
• The signal changes as shown in the figure below.
It means that the receiving conditions are bad and
the signal can not be controlled properly.
(Fig. 2)
2
O.K.
OUT
4