Electro-Voice Dx46 Bedienungsanleitung Seite 17

28 – ETHERNET
A computer and/or other ethernet devices (e.g. Dx46, NetMax N8000) can be connected via the Ethernet interface
for 100Base-TX / 10Base-T Ethernet networks. Normally this connection is established via a standard (straight
through) Ethernet cable and an Ethernet hub or a switch. The Dx46 can be connected directly with a computer or
another Dx46 using a standard or crossover Ethernet cable.
29 – B
Each output channel has an electronically balanced XLR connector for connection to system amplifiers. Each output
channel can output different frequency ranges depending on its assignment and cross-over settings.
CAUTION: Care must be taken to assure that each output is connected to an appropriate amplifier
30 – AES/EBU THRU
The AES/EBU THRU port allows looping-through the digital audio signal to other devices. The digital input signal
gets internally buffered and preprocessed (level matching / slew rate) before it is output via the THRU connector.
This allows fairly simple wiring between devices, without the need for AES/EBU distribution amps as they are usually
used. The Dx46 has a bypass-relay, which, in case of damage (e.g. power outage), connects the AES/EBU INPUT
signal directly to AES/EBU THRU. This ensures trouble-free operation of downstream devices.
31 – AES/EBU INPUT
In addition to the analog audio inputs, an AES/EBU digital stereo input is provided and selectable in the Setup
menu. The input conforms to IEC standard 60958 Type I. Connections must be made with three conductor, 110-
Ohm, twisted pair cabling and an XLR connector. Digital audio signals in AES3 format with a sample rate from 32
kHz to 192 kHz can be connected. Please note that the maximum cable length depends on the sample rate.
32 – LOCK LED
The LOCK LED lights green as soon as the AES/EBU input has been synchronized to the incoming signal and thus
proper audio transmission has been established. The LOCK LED is dimmed with no digital audio signal being pres-
ent at the input or the internal PLL not having locked on to the incoming signal.
33 – B
Each analog audio input is connected to an electronically buffered and balanced output as a through connector. The
signal does not run through any digital conversion or processing. These connectors are used to pass input audio to
a second Dx46 used as a slave or to other audio inputs in the system.
34 – B
Each input has an electronically balanced, locking XLR connector. In stereo or dual modes, connections to both in-
puts must be made. In mono modes, only one connection need be made, typically to Input A.
Downloaded from www.Manualslib.com
INTERFACE
XLR
ALANCED OUTPUTS
and loudspeaker to avoid damage or unexpected results. Note that a new preset may
change the assignment of channel and its frequency range. For instance an output
assigned to Hi frequency speakers in one preset, may be assigned as a sub output in
another. See "Configurations of the Dx46".
PORT
XLR THRU
ALANCED
XLR INPUT
ALANCED
manuals search engine
D 46
X
17