Dismantling The Rear Wheel; Install The Rear Wheel - Ghost E-HYBRIDE Andasol 4 Man Originalbetriebsanleitug

13.1.3 Dismantling the rear wheel

13.1.4 Install the rear wheel

Original operating instructions 11/2014
Downloaded from www.Manualslib.com
GHOST EPAC
1. Shift to the smallest pinion of the sprocket assembly on the rear wheel
(see section 8.2.2, Switching to a smaller sprocket).
2. Operate the rear brake until the rear wheel comes
to a complete stop.
3. Open the lever of your quick-release axle in accordance with section 8.4.1,
Opening, closing the quick-release axles .
4. Raise the bike at the rear end and push the gear shift mechanism
to the rear. In this position, push the rear wheel with alight pressure
towards the opening in the frame.
5. If your bike has a disc brake, insert the enclosed transport lock between
the brake pistons.
6. After removing the wheels, lay the bike carefully on its left side.
1. If your bike has a disc brake, remove the transport lock from the brake
pistons.
2. Raise the bike at the rear.
3. Place the rear wheel under the frame so that the chain fits over the smallest
pinion.
4. Lower the rear end carefully until the axle is on the stop of the open ends of
the frame on left and right.
5. With disc brake: Insert the wheel so that the brake disc slides smoothly
between the brake pads
manuals search engine
E - H Y B R I D E A N DA S O L & A N DA S O L X
E - H Y B R I D E T E R U & T E R U F S
EN
147