Switching To A Larger Sprocket; Switching To A Smaller Sprocket; Brakes - Ghost E-HYBRIDE Andasol 4 Man Originalbetriebsanleitug

EN
8.2.1
8.2.2
8.3

128
Downloaded from www.Manualslib.com
GHOST EPAC

Switching to a larger sprocket:

1. Please pedal in the direction of the drive.
2. Press lever A with your thumb beyond the first locking step until you hear a
clear click and hold it pressed until the desired gear is engaged.
3. If you would like to leave out several gears, press the lever right down and
hold it pressed until the desired gear is engaged.

Switching to a smaller sprocket:

1. Please pedal in the direction of the drive.
2. Pull lever B until you feel and hear it engage and then release the lever again
immediately.

Brakes

WARNING Danger from falls and accidents
If you operate the brakes too firmly this can lock the wheels and cause the
bicycle to skid or roll over.
Familiarise yourself with the use of the brakes. Begin by riding slowly and
operating the brake lever gently.
You should perform these braking exercises on level surfaces without any
road traffic.
Brake in a controlled manner and press both brake levers at the same time.
NOTE:
Disc brakes only develop their full braking power after a certain "running-in phase".
The rule of thumb is: After 30 brief braking operations from a medium speed
(approximately 25 km/h) down to a standstill the brakes are considered to have been
run in. Avoid long downhill riding for as long as your braking system has not been run
in. As soon as your braking system has been run in, the braking force at your disposal
is very strong. If you pull the brake lever too strongly, it is possible that the wheels will
lock.
NOTE: About 65% of the total braking power is provided by the front brake.
Maximum braking power is reached by simultaneously pressing both levers.
manuals search engine
E - H Y B R I D E A N DA S O L & A N DA S O L X
E - H Y B R I D E T E R U & T E R U F S
Original operating instructions 11/2014