Ghost E-HYBRIDE Andasol 4 Man Originalbetriebsanleitug Seite 148

EN
146
Downloaded from www.Manualslib.com
GHOST EPAC
4. Insert the wheel so that the brake disc slides smoothly
between the brake pads.
5. Lower the fork carefully until the axle is flush with the stop of the fork ends
on the left and right.
When clamping with the quick-release axle
Close the quick-release axle in accordance with section 8.4.1, Opening, closing
the quick-release axles .
6. If your EPAC has been retrofitted with a hub dynamo:
Reconnect the plug connector between hub dynamo and wiring.
7. Operate the front wheel brake several times with the EPAC stationary after
you have reinstalled the front wheel.
8. Lift up the EPAC by the handlebars and turn the front wheel by hand.
If a brake block is in contact with the wheel rim, this can indicate incorrect
mounting of the hub in the fork dropouts. In this case you should open the
quick-release lever and shake the front wheel lightly to and fro
(at right angles to the direction of travel).
Repeat the installation from step 5. If this does not improve the situation,
contact your specialist bicycle dealer immediately.
9. If your EPAC has been retrofitted with a hub dynamo:
Check that the lights are working correctly.
See section 6.9, Checking the .
manuals search engine
E - H Y B R I D E A N DA S O L & A N DA S O L X
E - H Y B R I D E T E R U & T E R U F S
Original operating instructions 11/2014