elero AstroTec-868 Original Bedienungsanleitung Seite 94

Troubleshooting/
General declaration of conformity
Troubleshooting
Problem
The sun and twilight
parameters cannot be connected or the light
changed and/or are
not displayed.
Roller shutter does
not move to the end
limit.
Transmission control Batteries are low.
light is flashing.
Transmitter doesn't
respond following
battery replacement.
General declaration of conformity:
The company elero GmbH hereby declares that the
AstroTec-868 is in conformity with the basic requirements and
other relevant provisions of the Directive 1999/5/EC.
EN-42
Cause
No light sensor is
sensor and/or the
connecting cable
is faulty.
No end limit position is Set the end limit
set.
Power supply was
interrupted for
too long.
Remedy
Check the light sensor,
connecting cable and
connector plug.
position using the
setting menu
PROG1/2.
Replace batteries.
Press RESET button.
Check settings.