elero AstroTec-868 Original Bedienungsanleitung Seite 61

Light sensors/Explanation of functions
Warnhinweise
Light sensors
Note: If you wish to connect a light sensor to the
AstroTec 868/-868 bidi, the instructions provided with
the light sensor must be followed.
Explanation of functions
MAN/AUTO sliding switch
In the "MAN " sliding switch setting, only manual command
controls are executed.
In the "AUTO
command controls are carried out (e.g. shade function, time,
astro function,...)
Transmission control light
A radio signal is indicated when the transmission control light
comes on. If the UP, STOP and DOWN buttons or programming
button P on the transmitter are held for a longer period, the
transmission control light will go out after 3, 6 and 9 seconds.
This function is a counting aid. After 12 seconds the transmission
control light will go out completely.
If the batteries are low, the transmission control light flashes during
the transmission process. The transmitter power and/or radio range
is reduced when the batteries are low. If the transmission control light
no longer lights up when a button is pressed, the batteries have to be
replaced.
Operating mode
The time is shown in the display.
OK button
When the OK button is pressed, the values currently displayed are
saved.
" sliding switch setting, manual and automatic
EN-9