Ordering Accessories; Warranty And Support; Recycling - Philips FC6723 Sicherheitsinformationen

English
10
Electromagnetic fields (EMF)
This Philips appliance complies with all applicable standards and regulations regarding exposure to
electromagnetic fields.

Ordering accessories

To buy accessories or spare parts, visit www.philips.com/parts-and-accessories or go to your Philips
dealer. You can also contact the Philips Consumer Care Center in your country (see the international
warranty leaflet for contact details).

Warranty and support

If you need information or support, please visit www.philips.com/support or read the international
warranty leaflet.

Recycling

- This symbol means that this product shall not be disposed of with normal household waste
(2012/19/EU) (Fig. 3).
- This symbol means that this product contains a built-in rechargeable battery which shall not be
disposed of with normal household waste (Fig. 4) (2006/66/EC). Please take your product to an
official collection point or a Philips service center to have a professional remove the rechargeable
battery.
- Follow your country's rules for the separate collection of electrical and electronic products and
rechargeable batteries. Correct disposal helps prevent negative consequences for the environment
and human health.
Removing the rechargeable battery
Only remove the rechargeable battery when you discard the product. Before you remove
the battery, make sure that the product is disconnected from the wall socket and that
the battery is completely empty.
Take any necessary safety precautions when you handle tools to open the product and
when you dispose of the rechargeable battery.
1 Disconnect the appliance from the wall socket and let it run until the motor stops.
2 Remove the dust container from the appliance.
3 Pull the display cover from the top of the handgrip (Fig. 5).
4 Undo the screw of the handle cover and pull the handle cover off the appliance (Fig. 6).
5 Undo the bottom cover screw (1) and then remove the side panels. (Fig. 7)
6 Remove the bottom cover screws on the left and right side (1). Then remove the bottom cover (2)
(Fig. 8).
7 Disconnect the battery connector and the display connector from the printed circuit board (Fig. 9).
8 Undo the battery frame screws (Fig. 10).
9 Remove the battery from the appliance and dispose of it according to the rules (Fig. 11).