Maintenance And Service - Bosch AdvancedGrassCut 36 Originalbetriebsanleitung

Lawn Trimmer/Lawn Edge Trimmer
Problem Possible Cause
Motor refuses to start Battery discharged
Battery too hot/cold
Garden tool functions On/Off switch defective
intermittently
Internal wiring of garden tool defective
Garden product la- Grass too high
bours
Garden tool does not Cutting line too short/broken off
cut
Spool empty
Cutting line can no Line inside the spool entangled
longer be fed
Spool empty
Cutting line retracts Cutting line too short/broken off
into spool
Cutting line breaks fre- Line inside the spool entangled
quently
Trimmer used incorrectly
Heavy vibrations Cutting line broken
Cutting system damaged
Grass between spool housing and line-feed but-
ton
Grass in hole for line feed
Battery and charger
Problem Possible Cause
Flashing red battery Battery not (properly) inserted
charge indicator
Battery contacts contaminated
No charging procedure
possible
Battery defective
Battery charge indicat- Mains plug of battery charger not plugged in
ors do not light up (properly)
Socket outlet, mains cable or battery charger de-
fective

Maintenance and Service

Maintenance, Cleaning and Storage
Before any work on the garden product itself (e. g.
u
maintenance, tool change, etc.) as well as during
transport and storage, remove the battery from the
garden product. There is danger of injury when uninten-
tionally actuating the On/Off switch.
For safe and proper working, always keep the product
u
clean.
Do not place other objects on the garden product.
Bosch Power Tools
Corrective Action
Recharge battery
Allow to cool/warm
Contact Bosch customer service agent
Contact Bosch customer service agent
Cut in stages
Manually feed cutting line
Replace line spool
Inspect the spool, rewind if necessary
Refill line spool
Remove spool – rethread line (see figures J − L)
Remove spool – rewind line (see figures J − L)
Only trim with the tip of the line, avoid stones,
walls and other hard objects. Feed the line regu-
larly to maintain full cutting diameter.
Pull out cutting line with manual feed (see figure
M)
Contact Bosch customer service agent
Disassemble spool cover and remove grass
Remove grass from hole for line feed
Corrective Action
Properly insert battery in charger
Clean the battery contacts (e. g. by inserting and
removing the battery several times) or replace
the battery
Replace the battery
Insert mains plug (fully) into the socket outlet
Check the mains voltage; have the battery char-
ger checked by an authorised after-sales service
agent for Bosch power tools
To ensure safe and efficient operation, always keep the
product and the ventilation slots clean.
Never spray the product with water.
Never immerse the product in water.
Store the product in a secure, dry place, out of the reach of
children.
Do not place other objects on the product.
Keep all nuts, bolts and screws tight to ensure safe working
with the product.
Inspect the product and replace worn or damaged parts for
safety.
Ensure replacement parts fitted are Bosch-approved.
English | 27
F 016 L94 127 | (24.11.2020)