STORZ & BICKEL Plenty Gebrauchsanweisung Seite 56

7. C O M M I S S I O N I N G A N D O P E R AT I O N
If the auto off release handle is
pressed while the PLENT Y is held in
the hand during operation, then the set
temperature level will be automatically
retained.
Once the temperature of the heat ex-
changer cools off, an automatic re-
heating will not occur; instead the cool-
ing process continues until the orange
auto off release handle is pressed
again.
As soon as the orange control lamp
turns off, the set temperature has been
reached, and the heat exchanger's
warming process is complete. Once
the desired preset temperature has
been reached, the vaporization cycle
can begin.
The current temperature can be read
from the thermometer.
If the temperature falls during vapori-
zation, then it is necessary to press the
auto off release handle again to restart
heating.
For technical reasons it is not
possible to measure the tem-
perature in the Filling Cham-
ber during the inhalation process. The
thermometer measures the tempera-
ture of the heat exchanger, and a cor-
responding calibration displays the re-
spective temperature in the Filling
Chamber during inhalation.
The auto off release handle
may not be fixed in the activa-
tion position (such as by tap-
ing or glueing it down). The manufac-
turer cannot accept any liability
whatsoever for damages caused by
alterations to the device or fixation of
the auto off release handle.
In case you prefer to keep the
PLENT Y standing up instead
of laying it on its side, you can
use the Cleaning Brush as a support,
by inserting the wooden handle in the
screwhole next to the rubber foot, as
shown.
Standing up the PLENTY Hot Air Generator
54