Installation Instructions - AEG Electrolux 88101KF-N Montage- Und Gebrauchsanweisung

Installation Instructions

Safety instructions
The laws, ordinances, directives and standards in force in the country of
use are to be followed (safety regulations, proper recycling in accord-
ance with the regulations, etc.)
Installation may only be carried out by a qualified electrician.
The minimum distances to other appliances are to be observed.
Drawers may only be installed with a with protective board directly
under the appliance.
The cut surfaces of the work top are to be protected against moisture
using a suitable sealant.
The sealant seals the appliance to the work top with no gap.
When building in, protect the underside of the appliance from steam
and moisture, e.g. from a dishwasher or oven.
Avoid installing the appliance next to doors and under windows. Other-
wise hot cookware may be knocked off the rings when doors and win-
dows are opened.
1
WARNING!
Risk of injury from electrical current.
• The electrical mains terminal is live.
• Make electrical mains terminal free of voltage.
• Observe connection schematic.
• Observe electrical safety rules.
• Ensure anti-shock protection through correct installation by a quali-
• The appliance must be connected to the electrical supply by a quali-
1
IMPORTANT!
Risk of injury from electrical current.
Loose and inappropriate plug and socket connections can make the ter-
minal overheat.
• Have the clamping joints correctedly installed by a qualified electri-
• Use strain relief clamp on cable.
• In the event of single-phase or two-phase connection, the appropri-
• If this appliance's mains cable is damaged, it must be replaced by a
Downloaded from www.Manualslib.com
fied electrician.
fied electrician.
cian.
ate mains cable of type H05BB-F Tmax 90° (or higher) must be used.
special cable (type H05BB-F Tmax 90°; or higher). The latter is availa-
ble from the Customer Care Department.
manuals search engine
51