Safety Information; Functions; General Function - BMW Advanced Car Eye 2 Bedienungsanleitung

Safety information

The ACE 2 may only be installed by a BMW
workshop.
The ACE 2.0 app must not be used by the driver
whilst the engine is running or whilst driving.
If you sell the device, ensure that you give the
buyer the operating manual and the declaration
of conformity sheet.
The ACE 2 must be reset to factory settings
using the ACE 2.0 app before it is passed on to
third parties.
Ensure that the micro SD card has been
formatted using the ACE 2.0 app before you
pass the device onto third parties.
The Wi-Fi settings can be reset to factory
settings using the button combination on the
front camera.
Press the Power key (1) on the rear and the
microphone ON/OFF key (2) on the side of
the front camera simultaneously for at least
3 seconds for this purpose.

Functions

General function

The ACE 2 consists of two full HD wide-angle
cameras, which can record accident incidents
whilst driving and property damage during
parking both in front of and behind your car. It
features proximity sensors at the front and rear
(radar sensors) and a vibration sensor (G sensor)
and can automatically or manually record media
data in the form of photos and video sequences.
It is primarily controlled using the ACE 2.0 app.
A defined logic system in the operating modes
described below enables the ACE 2 to monitor
the car.
Acoustic instructions and voice output keep you
up to date with the status of your ACE 2.
Not every recorded event means that
there is necessarily an incident involving
the car.
The installation and use of the ACE 2
may affect the fuel consumption, range
and starting capacity limit of your car.
33