Samsung dvd p390 Bedienungsanleitung Seite 11

Connection to a TV (Progressive)
1
Using component video cables, connect the COMPONENT
VIDEO OUT terminal on the rear of the DVD player to the
COMPONENT IN terminal of TV.
2
Using the audio cables, connect the AUDIO (red and
white) OUT terminals on the rear of the DVD player to the
AUDIO (red and white) IN terminals of TV. Turn on the
DVD player and TV.
3
Press the input selector on your TV remote control until
the Component signal from the DVD player appears on the
TV screen.
4
Set the Video Output to P-SCAN in the Display Setup
menu. (See pages 28-29).
You can use the VIDEO SEL. button to change the Video
Output mode. (See page 9).
To see the progressive video output,
- Consult your TV User's Manual to find out if your TV supports Progressive Scan. If Progressive
You need a TV set supporting the progressive scan
Scan is supported, follow the TV User's Manual regarding Progressive Scan settings in the TV's
input function. And you have to set up the TV
menu system.
- Depending on your TV, the connection method may differ from the illustration above.
Note
- What is "Progressive Scan"?
Progressive scan has twice as many scanning lines as the interlace output method has. Progressive
scanning method can provide better and clearer picture quality.
- There is no component video displayed when "SCART-RGB" Selected by pressing VIDEO SELECT
button on remote control.
WHITE
BLUE
RED
RED
Audio Cable
WHITE
RED
GREEN
RED BLUE
Please do not use Scart and Component
Video (Y, Pb, Pr) output simultaneously.
GREEN
Component cable
English _11