Velleman MONCOLH2 Bedienungsanleitung Seite 5

• Only use the device for its intended purpose. Using the
• Damage caused by disregard of certain guidelines in this
4.
Refer to the illustrations on pages 2 and 3 of this manual.
MONCOLH2
1
2
3
4
Connection
A monitor
B
5.
• Before use, make sure the battery is fully charged. To do
• Attach the wrist strap as indicated on page 3.
• Plug in the included signal cable [C] into the video input [9].
• Connect the other end [C1] to video output of a camera (not
• Switch on the LCD [1] with the On/Off button [2].
• The monitor now shows the camera images.
• Press the brightness button [3] until the desired display
• Press the colour button [4] until the desired display colour is
• Switch off the monitor before disconnecting the video cable.
6.
• The MONCOLH2 contains an internal rechargeable battery.
• Open the battery compartment [7] and remove the battery.
09.06.2010
Downloaded from www.Manualslib.com
device in an unauthorised way will void the warranty.
manual is not covered by the warranty and the dealer will
not accept responsibility for any ensuing defects or
problems.
Overview
LCD
On/Off
brightness
colour
power adaptor
Use
this, plug the power adaptor [B] into the power input [8].
The charge indicator [6] lights up bright. When the battery is
full, the charger indicator dims. Disconnect the adaptor.
incl.).
Note: do not connect the power output [C2] to the camera
as most cameras require 12VDC and this connector
only provides 5VDC.
brightness is reached (8 steps, circular).
reached (8 steps, circular).
Remember to reconnect the camera to the fixed wiring.
Battery
When the device is end-of-life, this battery has to be
disposed of in accordance with local regulations.
manuals search engine
MONCOLH2
5 wrist strap brace
6 charge indicator
7 battery compartment
8 power input
9 video input
C video cable
C1 video input
C2 power output (5VDC)
5
©Velleman nv