Herunterladen Inhalt Inhalt Diese Seite drucken

Command List; Output Parameters - TTI TGR2050 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 54
<WHITE SPACE>
<WHITE SPACE>
character (0AH).
The high bit of all characters is ignored.
The commands are case insensitive.

Command List

This section lists all commands and queries implemented in this instrument. The commands are
listed in alphabetical order within the function groups.
Note that there are no dependent parameters, coupled parameters, overlapping commands,
expression program data elements or compound command program headers; each command is
completely executed before the next command is started. All commands are sequential and the
operation complete message is generated immediately after execution in all cases.
The following nomenclature is used:
The commands which begin with a ∗ are those specified by IEEE Std. 488.2 as Common
commands. All will function when used on the RS232 interface but some are of little use.

Output Parameters

FREQ <nrf>
DBMLEV <nrf>
MVLEV <nrf>
UVLEV <nrf>
MODON
MODOFF
FM <nrf>
PM <nrf>
AM <nrf>
RFON
RFOFF
MOD_TYPE <nrf>
24
Downloaded from
www.Manualslib.com
is ignored except in command identifiers. e.g. '∗C LS' is not equivalent to '∗CLS'.
is defined as character codes 00H to 20H inclusive with the exception of the NL
<rmt>
<RESPONSE MESSAGE TERMINATOR>
<nrf>
A number in any format. e.g. 12, 12.00, 1.2 e1 and 120 e-1 are all accepted as
the number 12. Any number, when received, is converted to the required
precision consistent with the use then rounded up to obtain the value of the
command.
<nr1>
A number with no fractional part, i.e. an integer.
Set the output frequency to <nrf> kHz
Set the output level to <nrf> in dBm
Set the output level to <nrf> in mV
Set the output level to <nrf> in uV
Set modulation to ON
Set modulation to OFF
Set the FM peak deviation to <nrf> kHz
Set the PM peak deviation to <nrf> rads
Set the AM depth to <nrf> %
Switch on RF output
Switch off RF output
Select the modulation type according to <nrf> defined as:
1 = FM INT 400Hz
2 = FM INT 1000Hz
3 = FM EXT
4 = PM INT 400Hz
5 = PM INT 1000Hz
6 = PM EXT
7 = AM INT 400Hz
8 = AM INT 1000Hz
9 = AM EXT
manuals search engine

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis