Important Note; Precautions; Introduction; Location, Assembly And Connections - Ecler IC6CLASSTR Bedienungsanleitung

1. IMPORTANT NOTE

Congratulations! You are the owner of a carefully designed and manufactured piece of equipment.
We thank you for trusting in us and choosing our IC6CLASS-TR speaker for drop ceilings.
In order to get the optimum operation and efficiency from this unit, it is VERY IMPORTANT
- before you plug anything in - to read this manual very carefully and bear in mind all considerations
specified within. We strongly recommend that maintenance be carried out by our Authorized Technical
services.

2. PRECAUTIONS

Never use this unit in proximity to water. Do not expose the unit to water splashing.
Avoid placing the unit next to heat sources such as spotlights or heaters.
Use only the accessories specified by the manufacturer, adapted for each application.

3. INTRODUCTION

IC6CLASS-TR are built from a careful selection of components in a design that provides high
quality sound and fast installation with a minimum of tools.
Main characteristics:
•
2-way in-ceiling speaker
•
16Ω impedance, for easy installation of several units in parallel
•
Integrated high impedance transformer for use on 70/100V line distributed systems.
•
High or low impedance selector with 5 power taps, on the front of the unit once the speaker is
installed in the ceiling.
•
Woven Kevlar® woofer
•
Silk dome tweeter
•
Quick installation system using screw tabs with a minimum of tools

4. LOCATION, ASSEMBLY AND CONNECTIONS

For proper product installation, circular holes have to be made in selected places and the
appropriate wiring has to be prepared for each unit.
Here are the steps to follow for proper installation:
1. Make the mounting hole in the drop ceiling, after marking its outline with the supplied cutting
template
2. Strip and connect the two wires of the speaker cable end to the supplied loose Euroblock
terminal, respecting the polarity between the speaker (IN + and -), the other speakers of the
system and the amplifier feeding them. Insert the loose Euroblock connector of the cable into
the IN Euroblock terminal of the speaker.
3. Insert the speaker's frame into the hole, taking care that the 3 revolving fasteners remain in the
retracted position
4. Tighten each of the 3 screws accessible from the front of the unit. The revolving fasteners
rotate and at the end of the tightening, the frame is fixed at its final position
4