Lynx™ Bt Grundeinstellung - Datalogic Lynx Kurzanleitung

DATALOGIC
LYNX™ BT GRUNDEINSTELLUNG
DATA FORMAT – Symbology Independent Parameters
code identifier disabled, code length disabled, address stamping disabled,
address delimiter disabled.
DATA FORMAT – Symbology Dependent Parameters
custom code identifier disabled, symbology specific format = select all,
symbology character substitution disabled, symbology character deletion
disabled.
CAMERA CONTROL
exposure mode = automatic, based on entire image
POWER SAVE
illuminator power maximum, power off timeout with BT connection = 240 min,
power off timeout with no BT connection = 15 min.
READING PARAMETERS
trigger type normal, trigger level mode, flash on = 2 sec, flash off = 2 sec,
beeper tone = tone 1, beeper volume = high, beeper duration = 50 ms, user
defined beeper = tone 1, user defined beeper volume = high, user defined
beeper duration = 100 ms, code per scan = one code per scan, read per
cycle = one read per cycle, scan timeout = 5 sec, central code transmission
enabled, order by code length disabled, order by code symbology disabled,
autoscan mode disabled, autoscan aiming system enabled, autoscan
hardware trigger enabled, autoscan illumination system disabled.
IMAGE FORMATTING
Image Preset 1, 2, 3, 4
image format = JPEG, resolution = full (640 x 480), set JPEG quality
factor = 50, window origin = (0, 0), window dimensions = (640 x 480),
brightness = 0%, contrast = 0%, zoom = 100%, color depth = 256 gray level.
CODE SELECTION
exposure mode = automatic, based on entire image, issue identical code
disabled.
Standard Code 39: no check digit control, variable code length;
EAN 8/EAN 13 / UPC A/UPC E without ADD ON: UPCE expansion disabled
Interleaved 2/5: check digit control and transmission, variable code length
Code 128: variable code length
PDF417, Datamatrix, QR
12
enabled codes