Electrical Connection - AEG SWS98820 Gebrauchsanweisung

fter installing the unit, and particularly if the door hinge is reversed, please ensure
that the door seal is tight all round. n imperfect door seal can lead to increased
condensation and thus to higher energy consumption (see the section headed
"Troubleshooting").

Electrical connection

properly installed socket outlet with earthing contact is required for electrical con-
nection, positioned so that it is possible to pull out the mains plug.
The socket outlet with earthing contact used to connect the appliance should be
positioned on the left or right-hand side adjacent to the housing.
Electrical fuse protection of at least 10/16 amperes must be provided. If the socket
is no longer accessible once the appliance has been built-in, suitable measures
must be taken during electrical installation to ensure that the appliance can be dis-
connected from the mains (fuse, LP [line protection] contact opening width of at
least 3 mm).
Before operating the appliance, check the data plate to ensure compliance of the
connection voltage and type of frequency with the mains network values at the
installation site.
e.g. C 220 ... 240 V
220 ... 240V~
(i.e. 220 to 240 volt alternating current, 50 Hertz)
The dataplate is located inside the appliance on the top right-hand side.
50
50 Hz or
50 Hz