Weidmuller PTX800A Bedienungsanleitung Seite 45

ChangetheInputtypeinthesoftware:
1. Power up the instrument and start the setup routine.
. While the software version number is flashing, remove the security
link and press PGM.
. The display will show a number as shown in the table below.
Number
InputType
Outputtype
4. Change the number to suit your input and output types.
5. Replace the security link and press PGM.
Changetheoutputrangesettings:
6. Scroll through the setup and change the input type and range
settings - you will be required to calibrate the Inputs.
Calibratetheinput:
. Calibrate the inputs to the new output range and type.
Analogue
Output
Board
R3
R2
R1
0 1
mA V
mA mA
2 3
mA V
V V
Main Board
4 5
mA V
None None
45